Description
Jacuzzi Power Pro Bath Pump Flange Gasket (0199000) is the precise replacement seal you need to keep your hot tub running clean and leak-free. Specifically sized for the Power Pro bath pump, this gasket delivers a exact-fit seal that restores optimal pressure and efficiency after wear or damage.
Exact Fit, Precise Dimensions
Inside diameter: 2-3/16" (2.187"). Outside diameter: 2-5/8" (2.625" x 2.625"). These exact measurements ensure a reliable seal with the pump’s flange, avoiding common leaks caused by generic gaskets that don’t match the housing dimensions.
Compatibility & Replacement History
- Direct replacement for older gasket references: 199000, 306497, 9720-020, 9720-022
- Designed specifically for Jacuzzi Power Pro Bath Pump flange assemblies, ensuring a snug, wobble-free fit.
Why replace this gasket?
Over time, spa chemistry, temperature cycling, and pump vibrations can degrade seals, leading to drips, loss of pressure, and reduced heating efficiency. This gasket restores a tight seal between the pump flange and housing, helping maintain consistent flow, reduce water evaporation at the seal, and protect surrounding components from moisture exposure.
Ideal Use Scenarios
- Seasonal maintenance: replace worn gaskets at the start of the spa season to prevent unexpected leaks.
- Post-repair refresh: swap in a fresh gasket after pump servicing to ensure long-term reliability.
- Leak troubleshooting: if you notice dampness around the pump flange or reduced jet pressure, this gasket is a logical, exact-fit remedy.
Installation Tips
- Power off the spa and disconnect the pump from power to ensure safe handling.
- Drain or relieve pressure from the system as recommended by your spa’s manual.
- Remove the pump flange cover and old gasket. Clean both mating surfaces thoroughly to remove old sealant, mineral buildup, and debris.
- Place the 2-3/16" ID / 2-5/8" OD gasket onto the flange, aligning with bolt holes and the gasket groove.
- Reassemble the flange, tightening fasteners evenly in a crisscross pattern to avoid warping and ensure a uniform seal.
- Power up the spa and monitor for any leaks around the flange. If a leak persists, reseat the gasket and double‑check the mating surfaces for damage.
Care & Longevity
To extend gasket life, maintain balanced water chemistry and regular cleaning of the gasket seating surfaces. Avoid overtightening bolts, which can deform the gasket. If you notice cracking, hardening, or frequent leaks, replace with this exact-fit gasket to restore a reliable seal.
What You Get
A genuine, correctly sized flange gasket compatible with the Jacuzzi Power Pro Bath Pump, engineered to fit the 2-3/16" ID and 2-5/8" OD specifications and replace the listed part numbers for a seamless restoration of your hot tub’s sealing integrity.
| Part Type | Gasket |
| Inside Diameter | 2-3/16"id |
| Outside Diameter | 2-5/8" x 2-5/8"od |

